Hubbardton Forge 103047 - Manual (Page 2)

Installation Instructions
A298
Flora Chandeliers 10-3045 & 103047 Page 2 of 2
Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735 27015 Rev A
To Install Single Glass Option (Figure 2)
Component Parts
J Socket
K Bulb
(Included)
L Glass
M Retaining
Ring
N Retaining Ring Tool
1. Remove retaining ring (M) from socket (J) and retain.
Retaining ring ships installed.
2. Install light bulb (K). Be careful not to touch bulb with
bare hands; oil from the hands will dramatically reduce
bulb life.
Note: The bulb included is based on our design
preference; see the fixtures wattage sticker for Max
wattage information.
3. Slip glass (L) over socket (J) and thread retaining ring (M)
onto socket (J) using provided retaining ring tool (N).
4. Repeat steps 1-4 for remaining sockets.
5. Restore electricity at main breaker.
To Install Double Glass Option
(Figure 3)
Component Parts
J Socket
K Bulb
(Included)
L Glass
M Retaining
Ring
N Retaining Ring Tool
O Inner Glass
1. Remove retaining ring (M) from socket (J) and retain.
Retaining ring ships installed.
2. Install light bulb (K). Be careful not to touch bulb with bare
hands; oil from the hands will dramatically reduce bulb life.
Note: The bulb included is based on our design preference;
see the fixture wattage sticker for Max wattage information.
3. Place inner glass (O) inside glass (L) and then slip glass (L)
over socket (J). Thread retaining ring (M) onto socket (J)
using provided retaining ring tool (N).
4. Repeat steps 1-4 for remaining sockets.
5. Restore electricity at main breaker.
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
(Figure 2)
(Figure 3)
These illustrations represent a typical
fixture and may not match every style.