A341, Installation instructions – Hubbardton Forge 161080 User Manual

Page 2

If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased this product.
We hope you enjoy your fixture!

* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.

H U B B A R D T O N F O R G E . C O M

hand-forged, vermont-made lighting and accessories

154 RT. 30 SOUTH

•

CASTLETON, VERMONT 05735

28727 C

Installation Instructions

To Install the Canopy

(Figures 1 & 2)

(Continued)

7. Using suitable wire connectors (not provided) connect fix-
ture wires to supply wires (white to white, black to black).
Using the crossbar ground screw (B) and the cupped
washer (C) run a pigtail lead to the junction box and connect
all ground wires (bare copper or green to bare copper or
green).

CAUTION: MAKE SURE WIRE CONNECTORS ARE TWISTED ON
SECURELY, AND NO BARE WIRE IS EXPOSED.

8. Raise canopy (D) close to ceiling. Align holes in canopy (D)
with holes in crossbar (A) and secure with (2) #8 screws (E).

9. If fixture height needs to be adjusted to achieve desired
height, loosen knob and push up on canopy gripper (G) and
gently pull down/push up on supply/support cable (H).

Note: Excessive movement of cable through the gripper could

cause cable to fray slightly. Usage of the cable gripper is not
recommended to frequently adjust the fixture up and down in
height.

To Install Glass

(Figure 2)

Component Parts

F Fixture

I Barrel Knobs (3)

J Spider

K Socket

L Glass Shield

M Glass

1. Remove barrel knobs (I) from spider (J) and set them aside.

2. Install light bulb (not included).

3. Thread the glass shield (L) onto the socket (K).

4. Raise glass (M) and align holes with spider (J). Fasten glass

(M) to spider (J) using barrel knobs (I).

5. Restore electricity at main breaker.

A341

Brindille Glass Pendant Vintage Platinum 161080

Page 2 of 2

(Figure 2)