Hubbardton Forge 161065T - Manual (Page 2)

If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased this product.
We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
H U B B A R D T O N F O R G E . C O M
hand-forged, vermont-made lighting and accessories
154 RT. 30 SOUTH • CASTLETON, VERMONT 05735
30426 Rev A
Installation Instructions
To Install Glass (Figure 2)
Component Parts
C Fixture
D Thumb Screws
E Glass
1. Install bulb (not included). Be careful not to touch bulb with
bare hands; oil from the hands will dramatically reduce bulb
life. See notes below.
CAUTION: TO REDUCE THE RISK OF FIRE DO NOT USE A LAMP
IDENTIFIED FOR USE IN ENCLOSED LUMINAIRES.
2. Loosen the three thumb screws (D). It is not necessary to
remove them from the fixture.
3. Raise glass (E) until groove is aligned with thumb screws
(D).
4. Tighten the three thumb screws (D) equal amounts until
snug with glass (E). Be careful not to over tighten.
5. Restore electricity at main breaker.
INSTRUCTIONS PERTAINING TO A RISK OF FIRE, OR INJURY
IMPORTANT SAFETY INSTRUCTIONS
Lighted lamp is HOT!
WARNING – To reduce the risk of FIRE OR INJURY:
Turn off power and allow to cool before replacing lamp.
Lamp gets HOT quickly! Contact only switch/plug when turning
on.
Do not touch hot lens, guard, or enclosure.
Keep lamp away from materials that may burn.
Do not touch the lamp at any time. Use a soft cloth. Oil from
skin may damage lamp.
Do not operate the luminaire with a missing or damaged shield.
SAVE THESE INSTRUCTIONS
A349
Erlenmeyer Pendants 161060T & 161065T Page 2 of 4
(Figure 2)
E
D
C
(Figure 2- Continuity Test #1)