Hubbardton Forge 161025 - Manual (Page 2)

If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased this product.
We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
H U B B A R D T O N F O R G E . C O M
hand-forged, vermont-made lighting and accessories
154 RT. 30 SOUTH • CASTLETON, VERMONT 05735
All designs and images ©1989-2013 Hubbardton Forge ® . All rights reserved.
27971 B
Installation Instructions
To Install the Canopy (Figures 1,2 & 3)
(Continued)
7. Using suitable wire connectors (not provided) connect
fixture wires to supply wires (white to white or ribbed side
of the fixture cord, black to black or smooth side). Run a
pigtail lead from crossbar ground screw (F) to the junction
box and connect all ground wires (bare copper or green to
bare copper or green).
CAUTION: MAKE SURE WIRE CONNECTORS ARE TWISTED ON
SECURELY, AND NO BARE WIRE IS EXPOSED.
8. Raise canopy (G) close to ceiling and align with holes in
crossbar (D) and secure with (2) #8 screws (H).
9. If fixture needs to be lowered to achieve desired height,
loosen knob and push up on canopy gripper (I) and gently
pull down on supply/support cable (J).
Note: Excessive movement of cable through the gripper could
cause cable to fray slightly. Adjustment is for initial installation only.
Repeated adjustment is not recommended.
To Assemble Glass or Screen Option (Figures 4, 5 & 6)
Component Parts
C Bottom Assembly
K Tube Assembly
L 6-32 Screws (4)
M Screen
1. Remove tube assembly (K) from bottom assembly (C) by
removing four 6-32 screws (L) and separating tube assem-
bly (K) from retainer (O). Set all parts to the side for later use
(Figure 6).
2. Remove flat head screws (P) from tube assembly (K) and set
aside for later use.
3. Thread screws (P) through either screen (M) or glass tube
(N) depending on option purchased and into tube assembly
(K).
4. Tighten the three screws (P) equally into tube assembly so
that screen or glass is centered.
A321
Airis Low Voltage Pendants 161020 & 161025 Page 2 of 4
G
(Figure 3)
E
N Glass Tube
O Retainer
P Flat Head Screws (3)
H
I
J
F
D
C
(Figure 4)
O
K
P
L
(Continued)