Hubbardton Forge 306420 - Manual (Page 2)

If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased this product.
We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
H U B B A R D T O N F O R G E . C O M
hand-forged, vermont-made lighting and accessories
154 RT. 30 SOUTH • CASTLETON, VERMONT 05735
All designs and images ©1989-2013 Hubbardton Forge ® . All rights reserved.
30032
Installation Instructions
To Install Fixture (Figures 1 & 2)
(Continued)
4. Thread the wires in the electrical box through the center
hole in the wall mount bracket while moving the bracket into
position. Using the #10 screws (M), screw the bracket
securely to the wall. Be careful not to over-tighten or strip
the anchors.
5. Using two machine screws (not provided) attach mounting
bracket (E) to the electric box using inside oval holes to
orient fixture.
Note: A new electric box comes with screws. When replacing a
fixture, retain the screws for use with the new fixture.
6. Using suitable wire connectors (not provided) connect the
driver (J) wire with the white lead to the white supply wire.
Connect the wire with the black lead to the black supply
wire. Run a pigtail lead from crossbar ground screw (H) and
cupped washer (I) to the junction box and connect
all ground wires (bare copper or green to bare copper or
green).
CAUTION: MAKE SURE WIRE CONNECTORS ARE TWISTED ON
SECURELY AND NO BARE WIRES ARE EXPOSED.
7. Apply a generous bead of a suitable caulking material to
caulking lip (N) on the fixture. (Figure 3)
8. Carefully tuck all wires behind the fixture back (C) and inside
the wall mount bracket and place the fixture firmly onto
bracket (E). Fasten with #8 black screws (F) and rubber
washers (O) on top and #8 black screws (F) bottom.
9. Install two countersunk screws (G) through the fixture back
(C) and into the mounting bracket (E).
10. Continue with installation instructions following to assemble
fixture front and glass.
B302
Double Axis LED Outdoor Sconces: 306415D & 306420D Page 2 of 4
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL INJURY OR DEATH AND
PROPERTY DAMAGE. We recommend installation by a licensed electrician. This product must be installed in accordance with
applicable installation code(s), by a person familiar with the construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 2)
(Continued)
O
I
H
K
G
L
M
E
C
F
J
N
(Figure 3)