Hubbardton Forge 18450 - Manual (Page 2)

Assembly & Installation Instructions
A241
For Mobius Adjustable Pendant 18-450 Page 2 of 3
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 24425
Complete Assembly & Install Fixture
(Figures 3 & 4)
Component Parts
A Fixture Pipe
F Canopy
G Canopy
Ring
H Canopy Pipe
I Plastic Sleeve
J Clutch
K Set
Screw
L Ground Screw
Caution: Be sure power is off at the main breaker box prior to
installation.
1. Place canopy (F) over canopy pipe (H), followed by canopy ring (G). Make sure
smaller diameter side of canopy ring is oriented up toward the canopy.
2. Thread wires from the fixture pipe (A) through the canopy pipe (H).
3. Unscrew the clutch (J) from the canopy pipe (H); slide it across the wires and onto
the fixture pipe (A). Follow this with the plastic clutch sleeve (I), oriented so the
tapered end of the clutch sleeve nests in the clutch (Figure 3).
4. Slide the canopy pipe (H) as far as necessary to give you the total length of the
fixture which you desire. Be careful not to scratch the pipe surfaces and to pull
excess wire up through the canopy pipe (H). There must be a minimum 1-1/2" of
inner pipe inside the outer pipe. Hand-tighten the clutch to temporarily hold this
adjustment. The clutch is not securely fastened at this point; do not depend on it to
hold the fixture.
Important: To ensure full connection strength, be sure the tapered end of the
plastic clutch sleeve is oriented toward the clutch when assembled and securely
tighten set screw (Figure 3).
5. Carefully slide canopy ring (G) and canopy (F) down over fixture pipe (A) until
they rest on the fixture.
6. Using two machine screws (not provided), fasten the crossbar to the electric box.
Note: A new electric box comes with screws. When replacing a fixture, retain the
existing screws for use with the new fixture.
7. Using suitable wire connectors (not provided), connect fixture wires to supply
wires (white to white supply, black to black supply, and bare copper to bare
copper or green supply). Connect all ground wires to green ground screw (L).
Push wires back into outlet box.
Caution: Make sure wire connectors are twisted
on securely, and no bare wire is exposed.
8. Slide fixture canopy (F) against ceiling, and secure with canopy ring (G).
9. Once the fixture is fastened to the ceiling, tighten the set screw (K) firmly with
hex wrench provided.
10. Refer to instructions below to install glass and light bulb.
(continued)
(Figure 3)
(Figure 4)