A343, Assembly & installation instructions – Hubbardton Forge 18450 D User Manual

Page 2

If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased this product.
We hope you enjoy your fixture!

* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.

h u b b a r d t o n f o r g e . c o m

hand-forged, vermont-made lighting and accessories

154 rt. 30 South

•

caStleton, Vermont 05735

28828

Assembly & Installation Instructions

Complete Assembly & Install Fixture

(Figures 2 & 3)

(Continued)

2. using suitable wire connectors (not provided), connect

driver wires (d) to supply wires (white to white supply, black
to black supply). run a pigtail from the crossbar (c) to the
junction box using green ground screw (f) and cupped

washer (e). connect all ground wires (bare copper or green
to bare copper or green). Push wires back into outlet box.

CAUTION: make sure wire connectors are twisted on

securely, and no Bare wire is exposed.

3. Slide canopy ring (K) and canopy (J) over fixture pipe (a) so
that they rest on fixture. Smaller diameter side of canopy ring
(K) should be oriented up towards the canopy (J).

4. Place canopy (J) over canopy pipe (I), followed by canopy ring
(K). make sure smaller diameter side of canopy ring is oriented
up toward the canopy.

5. thread wires from the fixture pipe (a) through the canopy pipe
(I) (figure 3).

6. unscrew the clutch (m) from the canopy pipe (I); slide it across
the wires and onto the fixture pipe (a). follow this with the
plastic clutch sleeve (l), oriented so the tapered end of the
clutch sleeve nests in the clutch (figure 2).

Note: To ensure full connection strength, be sure the tapered end

of the plastic clutch sleeve is oriented toward the clutch when
assembled and securely tighten set screw (Figure 2).

7. Slide the canopy pipe (I) as far as necessary to give you

the total length of the fixture which you desire. be careful not
to scratch the pipe surfaces and to pull excess wire up through
the canopy pipe (I). there must be a minimum 1-1/2"of inner
pipe inside the outer pipe. hand-tighten the clutch to tempo-
rarily hold this adjustment. the clutch is not securely fastened
at this point; do not depend on it to hold the fixture.

8. carefully slide canopy ring (K) and canopy (J) down over fixture
pipe (a) until they rest on the fixture.

9. using #8 screws (h) that are shipped in crossbar (c), fasten
fixture bracket (g) to crossbar (c) taking caution not to pinch
any wires.

A343

For Mobius Adjustable Pendant LED 18450D

Page 2 of 3

D
E

(Figure 3)