Hubbardton Forge 138589 - Manual (Page 2)

Assembly & Installation Instructions
A317
Aura LED Lg Pendant 13-8589D Page 2 of 3
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 27825
(Figure 3)
5. Raise fixture and push support cables (F) through the canopy
(C) and into the cable grippers (G) until desired fixture height
is accomplished and level. Once desired height is
accomplished and product is level, tighten cable gripper locks
(Figure 3).
6. Using heavy duty cable cutters, cut excess supply/support
cable (F) allowing enough left (approx. 4”) to make
connections. Locate support cable (F) with a (+) label near
the fixture and slip the red isolation sleeve (provided) over the
end. Locate support cable (F) with a (-) label near the fixture
and slip the black isolation sleeve (provided) over the end.
7. Using suitable wire connectors (provided) connect support
cable (F) with red isolation sleeve to red driver wires with (+)
label attached. Connect support cable (F) with black isolation
sleeve to black driver wires with (-) label attached.
Caution: Make sure wire connectors are on securely, and no
bare wire is exposed.
Note: If using the supplied closed end connector, please use
the MR30A crimping tool. If the correct crimping tool isn’t
available, please use the alternate supplied connector (black
with set screw insert).
8. Remove canopy support cable (D) by removing #8 screw
(E) from one end and #8 nut from other end (discard cable).
Note: Flat head screws (H) will need to be removed from
ceiling bracket (A) prior to installation of the canopy (C).
The screws are shipped installed.
9. Raise the canopy (C) to the ceiling and attach to ceiling
bracket (A) with two flat head screws (H). (Figure 4).
10. Using suitable wire connectors (not provided) connect
fixture wires to supply (white to white or ribbed, black to
black or smooth). Connect all ground wires.
Caution: Make sure wire connectors are twisted on securely, and
no bare wire is exposed.
11. Thread canopy nipple (I) into threaded hole directly in
center of ceiling bracket (A).
12. Install canopy cover (J) on canopy nipple (I) (Figure 5, next
page).
13. Thread knob (K) on to canopy nipple (I). Tighten against
canopy cover (J) until snug
.
14. Refer to instructions following to install glass.
(continued)
(Figure 4)