A370, Installation instructions – Hubbardton Forge 135001 User Manual

Page 2

If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased this product.
We hope you enjoy your fixture!

* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.

H U B B A R D T O N F O R G E . C O M

hand-forged, vermont-made lighting and accessories

154 RT. 30 SOUTH

•

CASTLETON, VERMONT 05735

30901A

Installation Instructions

A370

Quill Pendant 135001

Page 2 of 3

(Continued)

(Figure 2)

(Figure 3)

(Continued)

BARREL NUT

HEX HEAD
SCREW

KEYHOLE

To Install the Canopy & Vertical Installation

(Figures 1 & 2)

CAUTION: MAKE SURE WIRE CONNECTORS ARE TWISTED ON

SECURELY, AND NO BARE WIRE IS EXPOSED.

9. Raise canopy (D) close to ceiling. Align holes in canopy (D)

with holes in crossbar (A) and secure with (2) #8 screws (E).

10. If fixture needs to be lowered to achieve desired height,

loosen safety nut, push up on canopy gripper (G) and gently

pull down on supply/support cable (H). Retighten safety

nut.
To Install Fixture Horizontally or Angled

(Figures 3 & 4)

Component Parts

F Fixture

M Support Cable

N Anchor

O #4 Screw

P Cable Gripper

Note: This fixture maybe oriented vertically or horizontally or any

angle in between.

1. Locate fourth decorative shield from canopy end of fixture.

Remove hex head screw and gently move the decorative

shield to gain access to keyhole. Insert barrel end of cable

(M) into large end of keyhole. Reattach decorative shield

with hex head screw. (Figure 3).

CAUTION: DO NOT LEAVE DECORATIVE SHIELD UNSUPPORTED, BY

THE WIRES.

2. Orient fixture to desired location and determine appropriate

location for ceiling cable gripper (P). With a pencil, mark

this location on the ceiling.

3. Drill 1/4" hole in the locations marked on the ceiling. Place

the tapered end of the anchor (N) into the hole and gently

tap flush to the wall using a light weight hammer

4. Unscrew gripper base from cable gripper (P). Slip #4 screw

(O) into gripper base and attach to ceiling by screwing

into anchor (N).

(Continued)