Allied Telesis AT-WA7501 - Manual (Page 99)

AT-WA7500 and AT-WA7501 Installation and User’s Guide
99
2. Configure the parameters for the radio. For help, see the next table.
3. Configure the advanced parameters for the radio. For help, see
“Configuring 802.11g Radio Advanced Parameters” on page 102.
4. (Master only) Configure inbound filters. For help, see “Configuring
802.11g Radio Inbound Filters” on page 107.
5. Click Submit Changes to save your changes. To activate your
changes, from the menu bar click Save/Discard Changes, and then
click Save Changes and Reboot. For help, see “Saving Configuration
Changes” on page 46.
6. (Optional) Configure security by clicking Configure security settings for
this service set. For help, see Chapter 6, “Configuring Security” on
page 169.
Table 29. 802.11g Radio Parameter Descriptions
Parameter Explanation
Frequency
(Master radio only) Choose the frequency that this access point uses
to transmit and receive frames. The available
frequencies depend on the country and the radio
option configured on the access point. See the
Table 30, ”Worldwide Frequencies for 802.11g
and 802.11b Radios” on page 101.
You may want to use a single frequency to isolate
the installation to part of the band; for example,
use a single frequency if other wireless networks
or microwave ovens are in the area.
For optimal performance of master radios in
access points that are in range of each other,
configure the frequencies to be at least five
channels apart. For example, configure the
frequency to use channels 1, 6, and 11.