Allied Telesis AT-WA7501 - Manual (Page 284)

Chapter 9: Additional Access Point Features
284
Using sdvars
Commands
Use sdvars commands to manipulate certain software download variables.
Sdvars commands support both GET and SET arguments. You can enter
sdvars commands to GET a software download object, and then issue the
sdvars command using the SET argument to assign the object a specified
value.
This section describes the sdvars commands using the SET argument. To
execute an sdvars command using the GET argument, omit the variable
from the end of the command.
sdvars set serveripaddress
Purpose: Sets the internal variable called serveripaddress to a specified
address.
Syntax: sdvars set serveripaddress ipaddress
where ipaddress is the address of the TFTP server.
Example: To set the IP address of the server to 192.168.49.29, enter:
sdvars set serveripaddress 192.168.49.29
sdvars set scriptfilename
Purpose: Sets the internal variable scriptfilename to a specified string. The
specified string should be the filename of the script to be retrieved from
the TFTP server.
Syntax: sdvars set scriptfilename foreignfilename
where foreignfilename is a script filename on the TFTP server.
Example: To set the scriptfilename to SCRIPT.DAT, enter:
sdvars set scriptfilename script.dat
Invalid opcode during write This error should not occur under normal
operating conditions. This error indicates
that the TFTP client does not conform to
the protocol.
Table 79. TFTP Server Stop
Error Message Explanation