Allied Telesis AT-VIEW PLUS 3.2 VLAN MANAGER User Manual
Page 18
Allied Telesyn
AT-VIEW PLUS
VLAN MANAGER
SNMP v3 Settings dialog box
User Account Name
This is the SNMPv3 User Account to be used for accessing the MIB of the target device.
Make sure to specify a User Account that has already been configured on the target
device.
Security Level
This is the Security Level for the User Account Name that you have specified. Make sure
to set the Security Level that is configured for the User Account Name on the target
device.
These are the available Security Levels:
No Auth / No Priv
This Security Level uses no authentication and no privacy.
Auth / No Priv
This Security Level uses authentication without privacy.
Auth / Priv
This Security Level uses authentication and privacy.
Note
- Do not use a user account with a security level of AUTHPRIV to connect to an
AT-9700 device. Doing so will result in the error message: "Unable to connect to '
functional."
Note
- VLAN Manager will not be able to connect to an AT-9700 device using an
SNMPv3 account that has SHA authentication if the previous connection established with
that device used an account with MD5 authentication. The same behavior will occur if
VLAN Manager tries to connect using an account with MD5 authentication when the
previous connection used an account with SHA authentication.
PN 613-50666-00 Rev C
Page 18 of 59