Allied Telesis AT-S97 - Manual (Page 77)

AT-S85 and AT-S97 Management Software Command Line Interface User’s Guide
77
SYSTEM SET INTERFACE
Syntax
system set interface id= chassis / slot [/ channel ]
opmode=link-test|ml|sml
Parameters
id Specifies a media converter module or a channel. The ID
consists of the following parts:
chassis Identifies the ID number of the chassis. The
chassis ID number depends on which module is
installed in the management slot of the chassis.
When a management module is installed in this
slot, the chassis ID number is 0 or 31. When a
stacking module is installed in this slot, the
chassis ID can be from 1 to 30.
slot Specifies the ID number of the slot with the
module. Possible values are:
1 or 2 Specifies a slot number of a media
converter module. In the
AT-MCF2000 Chassis, the left slot is
1 and the right slot is 2.
channel Specifies the number of the channel. Possible
values are:
1 to 12 Specifies a channel on the
AT-MCF2012LC and
AT-MCF2012LC/1 Modules. Channel
1 consists of twisted pair port 1 and
fiber topic port 1, channel 2 of twisted
pair port 2 and fiber topic port 2, and
so on. You can specify only one
channel at a time. Or, omit this
parameter to set all the channels on
a media converter module to the
same operating mode.
To view the ID and slot numbers of a chassis, refer to
“SYSTEM SHOW CHASSIS” on page 94 or “SYSTEM
SHOW CLUSTER” on page 97. To view the channels, refer
to “SYSTEM SHOW INTERFACE” on page 99.