Allied Telesis AT-S97 - Manual (Page 64)

Chapter 5: General System Commands
64
SYSTEM SHOW CLOCK
Syntax
system show clock
Parameters
None
Privilege Levels
Administrator, read-write, and read-only
Description
This command displays the current date, time, and Real Time Clock
(RTC) setting of the management module. This information is added to
event messages and SNMP traps. See Figure 9.
Figure 9. SYSTEM SHOW CLOCK Command
To manually set the date and time, use the SYSTEM SET CLOCK
command. If you set the time and date with the SYSTEM SET CLOCK
command, the RTC Source parameter is status is “manually.” For
information, refer to “SYSTEM SET CLOCK” on page 58.
To set the date and time from an Network Time Protocol (NTP) server,
refer to Chapter 7, “Network Time Protocol Commands” on page 111.
When you connect the NTP server and enabled the NTP server in
software, the RTC Source parameter is status is “NTP.”
Example
system show clock
System Clock Information
Date ............. 06/04/2007
Time ............. 03:35:25
RTC Source......... none