Allied Telesis AT-S97 - Manual (Page 184)

Chapter 10: File System Commands
184
FILE SHOW
Syntax
file show filesystem=system:// chassis / slot / filename
Parameters
system Specifies the chassis and module with the file system to
display. This parameter has the following parts:
chassis Specifies the ID number of the chassis with
the file. The value of the ID number is 0 or
31.
slot Specifies the ID number or letter of the slot
with the module. Possible values are:
m Identifies the slot with the
AT-MCF2000M Management
Module.
1 or 2 Specifies a slot with a media
converter module. In the
AT-MCF2000 Chassis, the left
slot is 1 and the right slot is 2.
filename Specifies the filenames to view. The
filename is case sensitive. You can use the
asterisk (*) as a wildcard.
To view the ID and slot numbers of the devices in a chassis
or stack, refer to “SYSTEM SHOW CHASSIS” on page 94
or “SYSTEM SHOW CLUSTER” on page 97.
Privilege Levels
Administrator, read-write, and read-only.
Description
This command displays the names of the files in the file system on a
management module. An example is shown in Figure 37. You might view
the file system to verify the spelling and case of the filename of a master
configuration file prior to designating it as the active master configuration
file or uploading it to a TFTP server.