Allied Telesis AT-S97 - Manual (Page 121)

AT-S85 and AT-S97 Management Software Command Line Interface User’s Guide
121
ˆ If the management module and syslog server are on different
networks, the IP configuration on the management module must
include a default gateway specifying the IP address of the first hop to
reaching the server. For instructions, refer to Chapter 4, “IP
Configuration Commands” on page 45.
Command
Summary
Table 8 summarizes the event log and syslog client commands.
Table 8. Event Log and Syslog Client Commands
Command Description
LOGGING CLEAR
EVENTLOG on page 122 Clears all the events from the log.
LOGGING DISABLE
EVENTLOG on page 123 Disables the event log. No further
events are stored in the log.
LOGGING DISABLE SYSLOG
on page 124 Disables the syslog client. No
further events are sent to a syslog
server.
LOGGING ENABLE
EVENTLOG on page 125 Activates the event log which
begins to store event messages.
LOGGING ENABLE SYSLOG
on page 126 Activates the syslog client.
LOGGING SET EVENTLOG
on page 127 Specifies the severity level of the
event messages viewed in the log
and sent to a syslog server.
LOGGING SET SYSLOG on
page 129 Specifies the IP address of a
syslog server and a facility code
for the messages.
LOGGING SHOW on
page 130 Displays the status of the event
log and syslog client.
“LOGGING SHOW
EVENTLOG” on page 132 Displays the event messages in
the event log.