Allied Telesis AT-S97 - Manual (Page 67)

67
Chapter 6
Port and Module Commands
This chapter contains the following sections:
ˆ “Overview” on page 68
ˆ “SYSTEM RESET CHASSIS” on page 70
ˆ “SYSTEM RESET CLUSTER” on page 72
ˆ “SYSTEM RESET MODULE” on page 74
ˆ “SYSTEM SET INTERFACE” on page 77
ˆ “SYSTEM SET MODULE” on page 84
ˆ “SYSTEM SET PORT” on page 87
ˆ “SYSTEM SHOW CHASSIS” on page 94
ˆ “SYSTEM SHOW CLUSTER” on page 97
ˆ “SYSTEM SHOW INTERFACE” on page 99
ˆ “SYSTEM SHOW MODULE” on page 106
Note
Remember to save your parameters changes in the active master
configuration file with the CONFIG SAVE command. For information,
see “Saving Your Configuration Changes” on page 17 or Chapter 9,
“Configuration File Commands” on page 139.