Allied Telesis AT-S97 - Manual (Page 73)

AT-S85 and AT-S97 Management Software Command Line Interface User’s Guide
73
After performing this command, you must do the following before you can
save new parameter changes:
1. Create a new master configuration file using the CONFIG SAVE
FILESYSTEM command or download a previously saved file from a
TFTP server. For instructions on the former, refer to “Creating a
Master Configuration File” on page 28 or “CONFIG SAVE
FILESYSTEM” on page 155. For instructions on downloading a file,
refer to “FILE DOWNLOAD” on page 172.
2. Designate the file as the management module’s active master
configuration file with the CONFIG SET command. For instructions,
refer to “CONFIG SET” on page 157.
3. To configure the modules according to the parameter settings in a
master configuration file downloaded from a TFTP server, issue the
CONFIG RUN command. For instructions, refer to “CONFIG RUN” on
page 153.
Note the following before performing this command:
ˆ The current date and time are retained.
ˆ The command does not affect power supply or fan modules.
ˆ This command ends your management session. To continue managing
the unit, you must reestablish the session after the management
module has initialized its AT-S97 Management Software. The
initialization process takes approximately one minute to complete.
Example
This command deletes all of the master and auxiliary configuration files on
the management and media converter modules in a chassis or stack and
returns the parameter settings to the default values:
system reset cluster