Allied Telesis AT-S97 - Manual (Page 158)

Chapter 9: Configuration File Commands
158
After designating an active master configuration file, do one of the
following:
ˆ To configure the modules in the chassis or stack according to the
settings in the newly designated active master configuration file, issue
the CONFIG RUN command. For instructions, refer to “CONFIG RUN”
on page 153. Do not issue the CONFIG SAVE command.
ˆ To overwrite the settings in the active master configuration file with the
current settings of the modules, issue the CONFIG SAVE command.
Note the following before using this command:
ˆ To view the name of the active master configuration file, see “CONFIG
SHOW” on page 159.
ˆ The designated file must already exist. To view the configuration files
in the management module’s file system, see “FILE SHOW” on
page 184. Configuration files have a “.cfg” extension. To create a new
configuration file, refer to “CONFIG SAVE” on page 154.
For further information, refer to “Specifying the Active Master
Configuration File” on page 142.
Examples
This command designates the file “mc22.cfg” in the file system on the
management module as the active master configuration file. The chassis
has the ID number of 1:
config set filesystem=system://1/m/mc22.cfg
This command designates the file “mcf2000 b12.cfg” as the active master
configuration file for the chassis with an ID number of 0:
config set filesystem=system://0/m/"mcf2000 b12.cfg"