Allied Telesis AT-S97 - Manual (Page 111)

111
Chapter 7
Network Time Protocol Commands
This chapter contains the following sections:
ˆ “Overview” on page 112
ˆ “NTP DISABLE” on page 114
ˆ “NTP ENABLE” on page 115
ˆ “NTP SET” on page 116
ˆ “NTP SHOW” on page 117
Note
Remember to save your parameters changes in the active master
configuration file with the CONFIG SAVE command. For information,
refer to “Saving Your Configuration Changes” on page 17 or Chapter
9, “Configuration File Commands” on page 139.