Allied Telesis x510 Series - Manual (Page 39)

x510 Series Installation Guide for Virtual Chassis Stacking
39
Switch ID LED The Switch ID LED, shown in Figure 10, displays the ID number of the
switch. A stand-alone switch has the ID number 0. Switches in a VCStack
have the numbers 1 to 4. Chapter 7, “Powering On the Stack” on page 89
has the procedure for verifying and, if necessary, changing the ID number
of the switch.
Figure 10. Switch ID LED
The states of the LED when the switch is not operating in the low power
mode are shown in Figure 11.
Figure 11. Switch ID LED
Switch ID LED
The switch is booting up.
The switch has encountered a fault condition.
The switch is operating as a stand-alone unit, with the ID
number 0.
The switch has an ID number of 1 to 4 as part of a VCStack.
The dot in the lower right corner flashes when the switch
accesses USB memory.