1 introduction, 1 overview, 2 hardware requirements – APC AP9608 User Manual
Page 5

1
1 Introduction
1.1 Overview
American Power Conversion’s Call-
UPS II
is a remote
UPS
management
device that allows you to monitor and control your
APC UPS
by modem.
It provides the following features:
•
Remote
UPS
status display
•
Remote
UPS
control (e.g., safe reboot during power
outage or when the server is down)
•
Data and event logging
•
Operator paging in case of trouble
Call-UPS II works with any
APC
Smart-
UPS
TM
, Matrix-
UPS
TM
or
Symmetra
TM
Power Array
TM
. It draws power from the
UPS
, and can be
used with the
APC
Measure-
UPS
TM
Environmental Monitor and the
APC
PowerNet
TM
SNMP
Adapter
TM
.
Call-
UPS II
comes in two versions: as an external device (
AP9208
) and
as a SmartSlot
TM
card (
AP9608
). SmartSlot Call-
UPS II
mounts in all
APC
devices equipped with a SmartSlot. The external Call-
UPS II
connects to
the
UPS
communications port.
1.2 Hardware Requirements
Call-
UPS II
requires an
APC
Smart-
UPS
, Matrix-
UPS
, Symmetra Power
Array or other
APC
device equipped with a SmartSlot. For paging or re-
mote management, Call-
UPS II
requires both a modem that understands
industry standard
AT
commands, and a telephone line. For configuration,
Call-
UPS II
requires local
DTE
equipment — either a dumb terminal or a
computer running terminal emulation software (e.g., HyperTerminal). A
remote management site requires its own computer with modem and ter-
minal emulation software. The communications rate for Call-
UPS II
can
be configured to 1200, 2400, 9600, and 19,200 baud. The default is
9600
.