APC AP9608 - Manual (Page 18)

14
The following fault conditions display only when Call- UPS II is used with
a Matrix- UPS and a fault condition exists.
• Runtime Calibration
• Waiting to Power Load
• Smart Boost
• Smart Trim
• On-Line
• On-Battery
• Low Battery
• Replace Battery
• In Bypass
• Sleeping – Delayed Wakeup
• Sleeping – Inverter Shutdown
• Forcing Graceful Shutdown
• Sleeping – Low Battery
• Shutdown Overload – Unable
to Transfer to Battery
• UPS Fault
The Status line at the bottom of the Status screen can display the follow-
ing
UPS status conditions:
If the UPS is powered off during a status request, Call- UPS II responds
with the message:
UPS Powered OFF
• Main Relay
• Batt Charger
• Bypass Relay
• Internal Temp
• Elec Unit Fan
• Iso Unit Fan
• Bypass Supply
• Voltage Select
• DC Imbalance