6 call-ups settings – APC AP9608 User Manual
Page 33

29
The top section of the Call-
UPS
Setup menu displays the following
Call-
UPS II
device information which will be needed in case technical
support is required:
•
Model Number — the model number of Call-
UPS II
•
H/W
Rev — the revision of the Call-
UPS II
hardware
•
Serial Number — the serial number of this Call-
UPS II
unit
•
F/W
Rev — the revision number of the Call-
UPS II
firmware
•
Manuf. Date — the date this Call-
UPS II
was manufactured
The remaining two sections of the Call-
UPS
Setup menu list changeable
settings of Call-
UPS II
. For a description of these settings, see the table
that follows.
4.6 Call-UPS Settings
To see or change Call-
UPS II
settings, go to the main menu and type 5,
then press
ENTER
. You will see the following display.
---------------------CALL-UPS SETUP ---------------------
Model Number:
AP9608
HW Rev: A2
Serial Number:
WA718570411
F/W Rev: K
Manuf. Date:
6/27/97
---------------------------------------------------------
1-
Set Date: Sep-28 ’97
7-
Ansi Color: Off
2-
Set Time: 10:38:06
8-
Baud Rate: 9600
3- Set Password: ********
9-
Answer Ring: 0
4-
Dial Back: OFF
10- Answer Lockout: 0 min
5-Dial Back Str: DT5551212
6-
Location: Physical Location of This UPS
---------------------------------------------------------
11-
UPS Present: ON
12- Reset Call-UPS to Default Settings
?- Help
>