3 ups control – APC AP9608 User Manual
Page 24
20
4.3 UPS Control
For remote control of the connected
UPS
, go to the Main menu and type 2
and press
ENTER
. Call-
UPS II
displays the Control menu.
Select from the menu items to perform the following:
UPS CONTROL
Command
Description
Turn UPS ON
Restores power to the load.
Turn UPS OFF
Cuts off power to the load immediately. This does not
allow for graceful shutdown for operating systems that
require it.
UPS Self Test
Starts a UPS self test and disp lays the results.
Simulate Power
Failure
Puts the UPS on battery for a moment as if there were a
power failure.
Graceful
Reboot
Causes the UPS to cycle power to the attached computer
to reboot it. Call-UPS II signals that the UPS is on
battery and that the battery is nearly exhausted. Graceful
Reboot uses the value set for Low Battery Duration. See
UPS Characteristics table, Sec. 4.4.
--------------------- CONTROL MENU ----------------------
1- Turn UPS ON
2- Turn UPS OFF
3- UPS Self Test
4- Simulate Power Failure
5- Graceful Reboot
6- Graceful Turn OFF
7- Start Runtime Cal (Stop Runtime Cal)
8- Put UPS in Bypass (Return from Bypass)
?- Help
>