APC AP9608 - Manual (Page 17)

13
UPS STATUS (Smart-UPS and Matrix-UPS)
Item Description
Utility Line Utility line input, in volts AC RMS.
UPS Output UPS output to the load, in volts AC RMS.
UPS Load Connected load as a percentage of the rated capacity of the UPS.
Run Time
Estimate of the total run time currently available from the
UPS, based on present load and battery, in minutes.
Load Power
Amount of power being drawn by the load, in volt-amps (if
supported by the UPS).
Load Current
Amount of current being drawn by the load, in amps (if
supported by the UPS).
UPS Temp Current temperature inside the UPS, in degrees Celsius.
Freq Output frequency of the UPS, in hertz.
Last Xfer
Reason for the last UPS transfer to battery. Possible results
are: Test, Low Voltage, Hi Voltage, Rate of Change, and
Notch/Spike.
Voltage Total voltage of the UPS batteries, in volts DC.
Capacity Battery charge as a percentage of capacity.
Smart Cells
Number o f Smart Cell battery packs connected to the UPS
(only with Matrix-UPS).
Bad Cells
Number of Smart Cells connected to the UPS that have gone
bad (only with Matrix-UPS).
Batt Date Date of the last battery change.
Self Test
Results o f the last UPS self-test. Possible results are: OK,
None (not available), Unable to Test (invalid results due to
overload), and Battery Failed (due to insufficient capacity).