Flytec 6020 * - Manual (Page 37)

Operating Manual Flytec 6020
3.2 Memory Management
Delete all Flights
Deleting the entire flight memory. This
command reformats the flight memory,
while all the other settings are not lost. 38 No
Delete all WP’s &
Routes Deleting all WP’s and Routes 21 No
Formatting Memory Reset of Basic values to factory settings 38 No
Delete all Air Space
CTR data Reorganisation of the Memory zone for the
Restricted Areas (CTR’s) 29 No
Caution: When deleting WPs, Routes or flights, the deletion process takes a couple of
seconds, please wait during this time span.
3.3 Instrument Settings
Term Denotation
more Factory setting
info
Display contrast Range 0 .. 100 % 70 %
Language Selection is possible from 5 different
languages English
Battery type Battery type. Selection possible between
Alkaline or NiMH accumulators Alkaline
Time zone Difference to UTC; 0.5h time zones can also
be set -2
Units Meter or feet; Km/h or mph or knots.
Temp. in °C or °F m ; km/h ; °C
Coordinate format dd'mm.mmm or dd.ddddd or dd'mm"ss UTM
or Swiss-Grid dd'mm.mmm
Pressure sensor Corr This setting allows correction of a possible
deterioration of the pressure sensor.
For checkup the QNH-value is used.
If you know the QNH-value of a certain
location (e.g. airfield altitude), the
altitude needs to be consistent with the
effective altitude. 1hPa corresponds at
500m to approx. 8m.
0 hPa
Bluetooth Only active when SW Package Bluetooth is
activated. Here is made the Pairing of the
Bluetooth interface for the SMS function.
SMS Only active, when Bluetooth and SMS
SW Package is activated. Here is entered
the target telephone number and the Mode.
Opt. Software Here are activated additional SW functions
(Packages). For this purpose the relevant
manufacturer’s Code is required.
Factory Settings Disabled Zone
- 37 -