Operating manual flytec 6020 – Flytec 6020 * User Manual
Page 16

Operating Manual Flytec 6020
damp
Dampening
The Variometer value is recalculated every 0.2s. In case of
rapid Vario changes and setting of quickly increasing tone pitch,
this may possibly result between two calculation phases in a
quite important modification of tone frequency. The ear perceives
this incidence as a kind of fast “piano effect”. In order to diminish this
effect, a damping feature may be fitted. Then rapid tone pitches are
honed in the frequency. As a result, the Vario sound has a smoother
response.
Pit.
Beep intervall
See graphic
0
2
4
6
8
10
12
14
5
10
15
20
25
30
Vario
number
beep tones
per second
beep tone short interval=7
beep tone long interval =1
Main Setup Menu
⇒
User Settings
⇒
Vario-Acoustics
⇒
Sink tone threshold .
The Sink tone is continuous and is heard with deeper sound pitch at increasing sink speed
and is slowly again increasing in frequency when approaching rising air.
Starting point
The starting point of sink acoustics can be selected just as in
climb acoustics. The threshold can be set by use of the
S T
arrow keys.
During flight the Sink tone can be switched-on or switched-off
by short pressure on the
key. Then one can see upon
switch-on the selected starting point in the analogue Vario
scale. Switch-off is just confirmed by a short beep of the key.
Main Setup Menu
⇒
User Settings
⇒
Vario-Acoustics
⇒
Vario Climb threshold
Starting point
In order to avoid the climb acoustics get started with immobile
aircraft, for ex. at take-off area, or at only slight climb, the climb
acoustics starting point can be set in the range from 0 cm/s up to
20 cm/s. Depending on the selected filter type, when climbing,
the Vario shall now activate vigorously or slowly
- 16 -