beautypg.com

3 the setting menus, 1 user settings, The setting menus – Flytec 6020 * User Manual

Page 36: User settings

background image

Operating Manual Flytec 6020

3 The Setting Menus

Prolonged pressing of the

OK

key gives access to the setting mode. With the arrow

keys

▼ and ▲ one of the menu items is selected and pressing the

OK

key gives access to

the relevant subdirectory.

3.1 User Settings


A series of settings allow the instrument to be programmed in accordance to the user’s
preferences. Every pilot may realise his very own ideas here. All the basic settings can be
set comfortably on the PC by use of the PC-Software „Flychart“ and be transferred later
to the instrument via the PC interface. Manufacturer’s approved basic settings are called-up
with Main Setup Menu

Memory

Memory format, and they are saved again in the

settings. Please note to use this setting in case of emergency only, because hereby all
waypoints and Routes shall be erased. In most cases the possible setting range and its
previously valid value is indicated individually for each of the settings. If this value should
be modified, pressing the

OK

key gives access to change mode, the value to be modified

will blink and can now be changed by use of the

▼ and ▲ arrow keys. Pressing the

OK

key

confirms the new value, pressing the

Page/ESC

On/Off

key recalls the previous setting.



Term Denotation

more

Factory

setting

Variometer

info

Ground filter

Diagnose of time constant f. Vario
and Speed

14

12 (

≈ 1,2 sec)

Digital Vario Integrator

Shift Integr.- Netto-Vario; Integr.-
time constant

14

Integr. 1 30 sec
1 sec

Thermal threshold

Threshold for the last climb

29

Variometer Acoustics

Acoustics settings

Climb tone frequency, modulation;
Sink tone frequency.
Acoustics dampening; Pitch

15

1200 Hz; Mod =
5,
700 Hz, 8, Pi = 3

Climb acoustics
activation threshold

Fine tuning of climb tone threshold,
max 20 cm

15

2 cm/sec

Sink tone activation
threshold*

Activation point of Sink tone

15

0,8 m/s (ft/m)

Speed

Sensor setting
Wind vane

Correction Wind vane 70 ... 150 %

17

100 %

Stall Speed

Activation of Stall alarm and altitude
limit

15

0 km/h (mph)

Flight Memory

Recording Auto/Man

Automatic or manual Flight recording 38

Aut.

Recording interval

Time interval per recording point -
2 to 30 seconds

38

10 Sec

Polar curves

Glide ratio at speed of best glide

28

L/D 8 to 40km/h

Pilot name

Entry of pilot’s name; max 25 char.

10

not set

Glider type

Name of aircraft for OLC

10

not set

Glider ID

Ident.No. of aircraft for OLC

10

not set



- 36 -