5 user defined fields, 6 entering text, User defined fields – Flytec 6020 * User Manual
Page 10: Entering text

Operating Manual Flytec 6020
1.5 User defined fields
The main screen as well as the final approach screen each show up to 3 pages which
are shifted by use of the
► key. Due to this feature it is possible to display nearly all
the following measuring data in their correct context. The page number is displayed below
the battery charge state as P1…P3.
page
Display remains empty
Time of day
Time of day
Flight time
Flight time since take-off
Vario
Digital Vario
Altitude 1 m
Absolute altitude in m
Altitude 1 ft
Absolute altitude in ft
Altitude 2
Reference altitude, can be set to 0 user-defined
Altitude Sum
Cumulated gained height of the flight
FL (ft)
Flight level in feet. Not alterable.
QNH hPa
Air pressure in Hektopascal
Gnd Speed
Speed over ground * ( = GS)
Air Speed
Flying speed through the air
17
Wind Speed
Wind strenght *
Spd-Diff
Wind component ( Groundspeed – True Airspeed )*
Track
Flight direction (course)*
Bearing WP
Direction to selected waypoint *
Dist WP
Distance to selected waypoint *
Dist Goal
Counted up sectors in front of the pilot up to the last WP
of a Route *
Dist Start
Distance from starting point
Dist Cylin
Distance to the radius of a Waypoint cylinder in a
Competition-Route
Dist Therm
Distance to last thermal *
L/D Gnd
actual Glide Ratio over ground (= Groundspeed/Sink)*
L/D Air
actual Glide Ratio through the air ( = TAS/Sink)
L/D Req
required Glide Ratio over ground to reach the WP*
Diff. BGWayp
Safety height above the path for best Glide *
Diff. BGGoal
Pre-calculated height at arrival above the last waypoint
of a Route *
Temperature
Temperature of circuit board
* Display only active when GPS receiver is energised.
If no data are changed after selection of a field, the instrument returns to normal mode
after 10 seconds and the previous display is maintained.
1.6 Entering Text
It is possible to enter text for certain fields, as for example pilot’s name, type of aircraft,
aircraft ID, or in regard to Waypoints or Routes the required text on the instrument.
However, this procedure is quite laborious. It is indeed much more easier to implement
the text entry on the PC by use of the program Flychart 4.52 and to transfer subsequently
the data to the instrument.
Text entry on the instrument is demonstrated here for the example of a Waypoint:
by use of the keys
▲ and ▼ one can select a single Waypoint and alter it after pressing
the
OK
key.
The 1st letter of the WP name shall be flashing. Now again by use of the
▲ and ▼ keys
the required letter is selected; numbers, letters as well as a range of special characters are
available.
- 10 -