Operating manual flytec 6020 – Flytec 6020 * User Manual
Page 30
Operating Manual Flytec 6020
CTR’s can be entered into the instrument either manually in Main Setup Menu
⇒
Airspace,
or with less effort by assistance of a PC-program, e.g. Flychart, this program may be
downloaded from our Internet Homepage at ().
•
Without activation the user has 20 CTR’s at his disposal. One can in Basic Settings ->
Init CTR’s call-up the CTR Innsbruck into the instrument and then alter it in
Main Setup Menu -> restricted areas.
•
With activation code there may be used up to 150 CTR’s, depending on how complex
they are. It is necessary to activate the SW Package 02 for this purpose.
The CTR is defined by endpoints and arc segments or just by a circle. When entering these
elements it must be taken care of that the endpoints are precisely created in their order of
appearance (to the right or to the left) in which these lines should be displayed later.
The 6020-GPS instrument draws automatically a line from the recent waypoint to the first one.
It is therefore not required to repeat as last waypoint the first one.
As type the following elements can be selected:
Point:
endpoint
Centre:
centre of arc segment
Startboarder:
Startpoint of arc segment
Stopboarder:
endpoint of arc segment
Circle:
centre of the circle plus Radius
example
counter-clockwise
CTR1 Alpnach
=================
Point
1/7
Point 2/7
Center 3/7
Startb. 4/7
Stopb. 5/7
Point 6/7
================⇓
Point
Lat
N 47’00.783
Lon E008’17.917
Ins
Del
Ele
Ele
Restricted areas
=================
CTR1 Alpnach
TMA 1 Alpnach
TMA 2 Alpnach
================⇓
Ctr1
CTR 1 Alpnach
Höhe FL130
No Elements:8
Ins
Del
Ctr
Ctr
7. Point
6. Point
5 Stopboarder
Dir -
4 Startboarder
Dir -
3 Center
2. Point
1. Point
6. Point
1. Point
2. Point
Information to
number of
endpoints /
elements
personal comment
Name of CTR
- 30 -