Horner APG SmartStack I/O HE-RTD100* - Manual (Page 2)

PAGE 2 10 NOV 2006 MAN0236-09
RTD000/100
This Data Sheet is published individually & also as a part of the SmartStack Supplement (SUP0246-05).
Information is subject to change without notice. SmartStack is a trademark of Horner APG, LLC.
2 WIRING
Signal
Pin
RTD100 RTD000
1E RTD1 Excitation RTD1 Excitation
1S RTD1 Sense RTD1 Sense
1C RTD1 Common RTD1 Common
Shield Shield
2E RTD2 Excitation RTD2 Excitation
2S RTD2 Sense RTD2 Sense
2C RTD2 Common RTD2 Common
Shield Shield
3E RTD3 Excitation
3S RTD3 Sense
3C RTD3 Common
Shield
4E RTD4 Excitation
4S RTD4 Sense
4C RTD4 Common
Shield
3 CONFIGURATION
Note: The status of the I/O can be monitored in Cscape Software.
Preliminary configuration procedures that apply to SmartStack
™ Modules are contained in the hardware
manual of the controller you are using. Refer to the Additional References section in this data sheet for
a listing of hardware manuals.
Module Setup Tab
a) Sensor Type for each channel may be selected independently.
b) Temperature format may be set for various C
° or F° ranges.
c) Filter Constant sets the level of digital filtering according to the chart below.
d) Reject Rates sets the frequency level for noise rejection at 50 or 60HZ.
I/O Map Tab
The I/O Map describes which I/O registers are assigned to a specific SmartStack
™ Module and where the
module is located in the point map. The I/O Map is determined by the model number and location within
the SmartStack
™. The I/O Map is not edited by the user.
*
OCS Bottom View – Shows
Corresponding I/O Pin
*
1E
1S
1C
2E
2S
2C
3E
3S
3C
4E
4S
4C
001RTD001