Horner APG RCX HE500OCX510 - Manual (Page 5)

OCX510 10 MAR 2003 PAGE 5
Information is subject to change without notice. SmartStack is a trademark of Horner APG, LLC.
5 INSTALLATION / SAFETY
a. All applicable codes and standards are to be followed in the installation of this product.
b. Use the following wire type or equivalent: Belden 8917, 16 AWG or larger.
For detailed installation information, refer to Mini Hardware Manual. A handy checklist is provided that
covers panel box layout requirements and minimum clearances.
6 INPUT / OUTPUT CHARACTERISTICS
7 TECHNICAL SUPPORT
North America:
(317) 916-4274
www.heapg.com
Europe:
(+) 353-21-4321-266
www.horner-apg.com
Warning: The default turns the outputs OFF when the controller enters idle/stop mode. To avoid
injury of personnel or damages to equipment, exercise extreme caution when changing the default
setting using the Module Setup tab.
35VDC
0
0.125(
±±15%) V -A
Digital Input Chart
Warning: Previous versions of this product provided internal fuses on the output
circuits (relay contacts). Due to CE Low Voltage Directive (LVD) marking
requirements, these fuses have been removed and replaced with solid
wire. Therefore, it is now the responsibility of the user of this equipment
to ensure that adequate fusing is installed externally on each relay output
circuit.
Warning: Consult user documentation. Warning: Electrical Shock Hazard.