Horner APG XL6 OCS HEXT351C115 - Manual (Page 2)

MAN0887-05-EN Specifications / Installation
__________________________________________________________________________________________________________________________________________________________________
3/2/2010 Page 2 of 8 #1037
2 Installation
1. Prior to mounting, observe requirements for the panel layout
design and spacing/clearances in the OCS XL Series Manual
(MAN0883).
2. Cut the host panel.
3. Insert the OCS through the panel cutout (from the front). The
gasket material needs to be between the host panel and the
OCS.
4. Install and tighten the mounting clips (provided with the OCS) until
the gasket material forms a tight seal.
5. Connect cables as needed such as communications,
programming, power and CsCAN cables to the ports using the
provided connectors.
6.
Begin configuration procedures.
3
Panel Cut-Out and Dimensions
Note: Max. panel thickness: 5 mm.
Refer to the XL6 User Manual (MAN0883) for panel box information and a handy checklist of requirements.
Connectivity
Serial Ports 2 Serial Ports – RS232 & RS485
Ethernet 10/100-Mbps (XL6e models only)
USB
USB Networking Port for communication with PCs
and programming Port
Removable
Media
Removable Media for upto 2 GB of storage for
programs, data logging or screen capture
Smartstix Remote IO modules communicating on CAN
Note: Highest usable frequency for PWM output is 65 KHz
Note: The tolerance to meet NEMA standards is ± 0.005” (0.1 mm).
Caution: Do not force the OCS into the panel cutout.
An incorrectly sized panel cutout can damage the
touch screen.
6.875”
[175mm]
[131mm]
001OCS003-R1
5.156”
R .125” [3 mm] TYP.
RADIUS CORNERS
WHEN REQUIRING
DUST OR WATER
TIGHT SEAL PER
NEMA 4, 4X OR 12
001XLQX007