Horner APG XL6 OCS HE-XL1E14 - Manual (Page 7)

MAN0902-01-EN Specifications / Installation
__________________________________________________________________________________________________________________________________________________________________
3/26/2009 Page 7 of 7 ECN # 956
10 Technical Support
For assistance and manual updates, contact Technical Support at the following locations:
North America:
Tel: 317 916-4274
Fax: 317 639-4279
Web:
http://www.heapg.com
Email: [email protected]
Europe:
Tel: +353-21-4321266
Fax: +353-21-4321826
Web:
http://www.horner-apg.com
Email: [email protected]
All applicable codes and standards need to be followed in the
installation of this product.
Adhere to the following safety precautions whenever any type of
connection is made to the module:
Connect the safety (earth) ground on the power connector first before
making any other connections.
When connecting to electric circuits or pulse-initiating equipment, open
their related breakers.
Do not make connections to live power lines.
Make connections to the module first; then connect to the circuit to be
monitored.
Route power wires in a safe manner in accordance with good practice
and local codes.
Wear proper personal protective equipment including safety glasses
and insulated gloves when making connections to power circuits.
Ensure hands, shoes, and floors are dry before making any connection
to a power line.
Make sure the unit is turned OFF before making connection to
terminals.
Make sure all circuits are de-energized before making connections.
Before each use, inspect all cables for breaks or cracks in the
insulation. Replace immediately if defective.
• Use Copper Conductors in Field Wiring Only, 60/75° C.
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including
interference that may cause undesired operation.
Radiated Emission Compliance: For compliance requirement, a
ferrite (Horner P/N FBD006 supplied with the unit) needs to be placed
on the AC/DC line with one loop.
"WARNING: EXPOSURE TO SOME CHEMICALS MAY DEGRADE
THE SEALING PROPERTIES OF MATERIALS USED IN THE Tyco relay PCJ
Cover / case & base: Mitsubishi engineering Plastics Corp.
5010GN6-30 or 5010GN6-30 M8 (PBT)
Sealing Material: Kishimoto 4616-50K (I part epoxy resin)
It is recommended to periodically inspect the relay for any
degradation of properties and replace if degradation is found
No part of this publication may be reproduced without the prior agreement and written permission
of Horner APG, Inc. Information in this document is subject to change without notice.