MagTek InSpec 9000 - Manual (Page 87)

Appendix D. Error Messages
77
Track (1,23) LRC check has Failed
and/or
Track (1,2,3) Parity check has Failed
CARD MAY NOT BE READABLE IN THE FIELD!
LRC and Parity are used to detect data errors. This message indicates that an error in the
data, Parity, or LRC was detected.
Unit attached is not setup!
Each tester must be set up on each PC that it is used on.
Unit Not Responding!
There is no communications between the PC and the tester. Ensure that the
communications cable is plugged into the PC and the tester and the correct Com Port has
been selected.
Unit Time up, Start Trans!
Communications between the PC and the Tester were interrupted.
Unit Time Out, …
The tester did not respond to the PC software. Check power and communication cables
on the tester.