MagTek InSpec 9000 - Manual (Page 86)

InSpec 9000 Encoded Card Tester
76
Please complete the Card Parameters Selection!
A selection must be made in all three card parameters.
Please enter Data for all graph parameters
The graph requires that all graph parameters have valid data. This message indicates that
one or more graph parameters have not been selected.
Setup Unit before use!
Each tester must be setup before first use on each PC. See Setup in this manual for
information on how to setup the tester.
Start Sentinel Not Found On Track (1,2,3)
Card May Not Be Readable In Field.
Start Sentinel Character was not found at the start of the binary data on the specified
track. This has no effect on Start Sentinel location, which is determined by the first one-
bit detected.
Start Sentinel On Track (1,2,3) Is Excessively Close To The Leading Edge.
Card May Not Be Readable In Field.
Start Sentinel is close enough to the leading edge of the card as to make the track
unreadable in some readers.
The Password You Have Entered Is Not Correct.
Please Renter The Password.
The user has mistyped the password or entered the incorrect password. Technical support
can decrypt passwords if necessary.
The password you type does not match the password in the Confirm box!
The passwords in each box must match.
To change the password, the user must enter the same password in NEW and CONFIRM.
This ensures that the password does not contain a typing error.