MagTek InSpec 9000 - Manual (Page 38)

InSpec 9000 Encoded Card Tester
28
MagTek will use the information to either produce a new setup card or to recommend service.
CALIBRATION VERIFICATION
Calibration may be verified by using the “test card” Supplied with the InSpec 9000. This may be
done as follows:
1.
From the Main Screen select the following: Card Stock: Test Card; System: InSpec;
Shift: Test.
2. Click on the read button to read the “test card”.
3.
From the ISO Parameters bar chart screen, click on “Numerical”, then compare the
average amplitude, average bit size and start sentinel values from the numerical screen to
the values for all three tracks on the form included with the cards. Check to see if the
readings are within the measurement uncertainty found at the bottom of the screen on
Figure 3-11.