MagTek InSpec 9000 User Manual

Page 2

1996-2005

MagTek

, Inc.

Printed in the United States of America

Information in this document is subject to change without notice. No part of this document may be
reproduced or transmitted in any form or by any means, electronic or mechanical, for any purpose,
without the express written permission of MagTek, Inc.

MagTek and InSpec 9000 are registered trademarks of MagTek, Inc.
Microsoft, MS, and MS-DOS are registered trademarks, and Windows is a trademark of Microsoft
Corporation.

REVISIONS

Rev

Number

Date Notes

9/27/96

Release for Pre-Production Beta Units

12/18/96

Deleted Calibration, added Setup, and complete revision except for
Appendices

1/16/97

Changed Setup screen to add “Cleaning Cycles” and “Total Setup”
in Section 2. Spec change, Card Parameters, Section 1

2/24/98

Updated all screen captures to Windows 95; Changed
Requirements and Specs Sec 1; Added Roller Cleaning, added
Security to Main Screen Fig 3-2, Sec 3; Added Card Failures and
Noise Detection and Security to Sec 3, Figs 3-4, -5, -6, -7, -8; Added
Calibration and Verification Procedure, and Fig 3-11 to Sec 3;
Added new Figs 4-2, -5, Sec 4; Added message to troubleshooting
table Sec 5; Added Appendix D, Error Messages; Added Index.

4/2/98

Added Product Information to front matter. Changed analysis area in
Spec, Sec 1. Changed cleaning procedure, Sec 2. Added Noise
Detection description, and changed Figs 3-2, 3-7, and 3-11, Sec 3.
Changed Figs 4-4, 4-5, 4-6, and 4-8, Sec 4.

8/4/98

Added phone number on title page. Section 1: added part numbers.
Section 2: added installation disks; added cleaning, test card, and
head polishing procedures. Section 3: added 'password' to index.
Section 4, Figure 4-2 and 4-3: changed illustration and related text
to update.

4/21/99

Sec 1. Clarified note to state that cards within ISO 7810 spec can be
read. Added card-cleaning precaution. Sec 2. Combined Head and
Roller cleaning procedure to reflect software change which adds
second cycle to cleaning; Added caution note for letting unit dry
before inserting a card.

9/6/01

Front Matter: Updated agency approval status and Safety page.

4/15/03

Front Matter: added ISO line to logo, changed Tech Support phone
number, added new warranty statement.

7/13/04

Sec 1, Requirements, MagTek Supplied: Test Cards (2) Changed
P/N 96700033 to 96600033.

8/5/04

Sec 1, Requirements, MagTek Supplied: Deleted 3 ½ “ disk and
added CD P/N 39810316.

8/24/04

Throughout: Deleted references to Windows 95. Sec 2: Replaced
Software Section.