Triton Bathymetry - Manual (Page 25)

Page 21
5.1.8 Tide/Squat Processing
The XML files created earlier for tides and squat can be applied at this stage of the
processing wizard. The example shown below is using a single tide file, however a folder of
tide files can be selected and an interpolated value for the current location will be used
from the three closest stations. At the base of this page of the processing wizard is
where an XML squat table can be loaded if available.
A few things to point out about this page of the wizard:
 Note that the tide file used is graphed and compared with the survey time to
confirm they overlap.
 If RTK tide data is present in the raw data file tides can be applied without a
separate tide file by selecting the GPS Tides option.
 This is the final page of the BathyOne wizard and selecting Finish will start the
processing routine.