Ask Proxima 9100 - Manual (Page 28)

Setting Up Your Projector 1-15
DEC 3C3 Video Connections
If you have a DEC workstation with 3C3 connectors at the computer and
monitor video ports:
Figure 1-19, 3C3 connector
1 Disconnect your computer-to-monitor cable at the computer end.
2 Connect the free end of the monitor cable to the Proxima DEC 3C3 to
LCD adapter (C947-10).
3 Connect the free end of the DEC 3C3 to LCD adapter to the projector’s
COMPUTER OUT connector.
4 Use the Proxima DEC 3C3 to LCD connector cable (C948-6) between the
projector and the computer. Connect the end marked “LCD” to the
projector’s COMPUTER IN connector, and the end marked “COMPUTER”
to the workstation’s video output connector.
BNC Video Connections
If your workstation does not have a 13C3 video port connector at the
computer video port, but has a BNC connector at the monitor, you will need
the optional Proxima BNC cables.
1 Note which BNC connectors are currently used with the monitor. (The R,
G, and B connectors are always used, but the way the H and V connectors
are used depends on your configuration.) Disconnect your
computer-to-monitor cable at the monitor (BNC) end.
2 Connect the free BNC end to the optional Proxima BNC Block to LCD
Connector Cable (C942-2), connecting the same BNC connectors used
on the monitor. Plug the “LCD” end of the cable into the projector’s
COMPUTER IN connector.
Computer Video Out To Projector
R
G
B
H
V
Figure 1-20, Using the BNC Block to LCD connector cable