Red Lion LEGEND - Manual (Page 42)

INSTALLATION & REMOVAL OF OPTIONAL RELAY BOARD
To install the relay board, locate the relay opening at the lower right-hand
corner, on the back of the Legend. Using a small screwdriver, inserted into the
slot of the relay latch, bend the tab down while sliding the board into the two
slots in the housing. The relay board will seat into the unit, allowing the tab to
return to its original position. To remove the relay board, pull down on the tab
just enough to allow the relay board to slide out. Grasp the terminal block and
pull to remove the board.
DIP SWITCH SET-UP
The DIP switches are accessible through the side of the Legend. The DIP
switch positions and their functions are shown below:
-40-