Vaisala vLog 4.5 - Manual (Page 53)

Configuring Loggers: Batch Setup (vLog VL)
Vaisala Veriteq vLog 4.5 47
5 To set logger sample timing settings, click Modify in the
Logger Sample Timing Settings area. In the window that
appears, set start mode, stop mode, sample interval, and
so on. Click
OK .
6 To set logger description, select the Modify checkbox and
enter a new description (depending on your regional font
settings, the space available for the description may be
less than 16 characters).
7 If desired, enable or disable channels.
8 To modify channel descriptions, select the Modify
Description checkbox for the channel to modify and enter
a new description.
9 Click Setup Logger (you can click Close to close without
saving).
10 If security is enabled, enter your password, then click
OK.
11 When the Confirm System Time dialog appears confirm
the exact time before clearing the logger. Click
OK .
12 Confirm any changes to the description(s). Click OK .
13 A message appears showing the changes to be made,
asking if you want to continue. Click
Yes .
Second and subsequent loggers if performing Batch Setup
using only one COM Port:
1
With the Logger Batch Setup window still open,
disconnect the current logger from the logger cable and
attach the next logger to be configured.
2 On the Logger Batch Setup window, change the logger
or channel descriptions if desired.
3 Click Setup Logger .
4 Confirm the changes to the logger and descriptions. Click
OK .
5 A message appears showing the changes to be made,
asking if you want to continue. Click
Yes .
6 The settings as specified will be applied to this logger.
7 Repeat steps 1 through 6 for all remaining loggers.
8 When all loggers have been setup, click View Report if
desired, otherwise, click Close .