Vaisala HMP110 - Manual (Page 49)

Chapter 4 ________________________________________________________________ Operation
VAISALA _______________________________________________________________________ 47
Other Commands
Set Analog Output Mode
Use the AMODE command to show or set the operation mode of the
analog output.
AMODE [ch1] [ch2]
where
ch1
= Analog output mode for channel 1, range 0 ...3.
The options are:
0 (0 ... 1 V)
1 (0 ... 2.5 V)
2 (0 ... 5 V)
3 (1 ... 5 V)
ch2 = Analog output mode for channel 2, range 0 ...3.
The options are the same as for channel 1.
Example (show current output modes):
amode
Ch1 output : 0 ... 1 V
Ch2 output : 0 ... 1 V
Example (set channel 1 to 0 ... 1 V and channel 2 to 0 ... 5 V):
amode 0 2
Ch1 output : 0 ... 1 V
Ch2 output : 0 ... 5 V