Vaisala HMP110 - Manual (Page 25)

Chapter 3 _______________________________________________________________ Installation
VAISALA _______________________________________________________________________ 23
Mounting the HMP60, HMP110 and HMP110T
Probes
HMP60, HMP110 and HMP110T are designed to be mounted from the
M12 thread on the probe body or from the smooth part of the probe body.
For a convenient installation, use the optional installation accessories:
- Use the plastic mounting nuts to hold the probe in a through-wall
installation.
- Use the probe mounting clamp to hold the probe on a wall.
- Use the probe mounting flange to hold the probe in a through-wall
installation.
NOTE Avoid placing the probe in a place where condensation can run onto the
sensor.
Probe Assembly with Duct Installation Kit
0505-177
Figure 18 Assembly of the Probe with Duct Installation Kit
The following numbers refer to Figure 18 above:
1 = HMP60, HMP110 or HMP110T probe
2 = Duct installation kit
3 = Probe cable
1. Slide the probe cable through the duct installation kit plastic pipe.
2. Attach the cable to the probe.
3. Attach probe assembly to the duct.
2
1
3