Inserts – Sandvik Coromant Parting and grooving - users guide User Manual
Page 10
8
CoroCut 1- and 2-edge inserts
– the first choice system
Inserts
This system is based on a patented Rail and V-shaped design which, together with a long
insert, gives exceptional stability. These factors make it possible to run at higher cutting data
and to achieve better productivity than any other system on the market.
Insert
Holder
V-shape
Rail-shape
The inserts are available in different insert seat sizes covering inset widths from 1.5 mm up
to 8 mm, having different corner radii.
The insert seat sizes (D–L) must correspond with the holder seat size.
Most of the inserts are 2-edged versions in order to give good economy. Note that the
maximum cutting depth, ar, for these inserts is limited, see the table.
If larger depth is needed, use the 1-edged solution which can cut as
deep as the blade will allow.
Insert seat size
Insert width,
mm
from
Max. cutting
depth, a
r
, for
CoroCut 2
inserts, mm
D
1.5
12.9
E
2
19
F
2.5
18.9
G
3
18.8
H
4
23.7
J
5
23.6
K
6
23.5
L
8
28.4