Outback Power Systems VFX Series International Programming Manual - Manual (Page 5)

4
WELCOME TO THE OUTBACK POWER SYSTEMS FX SERIES
INVERTER/CHARGER SYSTEM
The FX and VFX Series Inverter/Charger off ers a complete power conversion system—DC to AC,
battery charging, and an AC internal transfer relay—for stand-alone applications.
OutBack Power Systems does everything possible to assure the components you purchase will
function properly and safely when installed as instructed according to local and national electrical
codes. Please read all of the following instructions and the instructions that come with any OutBack
components included in your power system. Further instructions on individual FX set-ups as well as
systems assemblies are included with the International FX and VFX Series Inverter/Charger Installation
Manual.
The OutBack Power Systems FX and VFX is ETL listed to UL1741 (Inverters, Converters, Controllers, and
Interconnection System Equipment for Use with Distributed Energy Resources). All Mobile FX Series
Inverter/Chargers are ETL listed to UL 458.
Grounding Instructions
Each FX should be connected to a grounded, permanent wiring system. For most installations, the
negative battery conductor should be bonded to the grounding system at one (and only one) point in
the DC system. All installations must comply with all national and local codes and ordinances.
The equipment ground is marked with this symbol:
The International FX and VFX Series Inverter/Charger Programming Manual covers the following
information:
• Safety
• Programming or “stacking” multiple FXs using the OutBack Power Systems MATE
• Explaining the FX modes and properties.
IMPORTANT SAFETY INSTRUCTIONS
KEEP THESE INSTRUCTIONS
General Precautions
1. Use caution whenever working around electricity, electrical components, and batteries. There is
always a potential for shocks, burns, injury, and even death if an installer or user comes in contact
with electricity.
2. Read all instructions and cautionary markings on the FX, the batteries and all appropriate sections of
this manual as well as other component manuals before using the system.
3. Be sure each system FX is securely installed according to the International FX and VFX Series Inverter/
Charger Installation Manual.
4. Follow all local and national electrical codes when installing OutBack equipment and components.