Programming the fx – Outback Power Systems VFX Series International Programming Manual User Manual
Page 27

26
Once the MATE recognizes each FX (and OutBack Charge Controller), push and hold the fi rst two soft
keys simultaneously to return to the MAIN menu. To program the FXs, go to the ADV/FX/STACK menu
on the MATE navigating with the following steps:
Press the
NOTE: Pressing and holding the fi rst two soft keys
at the same time will always bring up the Main
Menu screen.
Push any soft key on the ADV/SETTINGS/
WARNING screen and go to the ADV/PASSWORD
screen.
MAIN--------------------------
12:12:16A
SUM STATUS SETUP ADV
ADV/SETTINGS/WARNING
changes made could
adversely aff ect
system performance
PROGRAMMING THE FX
S
The screen displays 132. Press the
button until it scrolls to the password 141.
ADV/PASSWORD---------------
enter the password
132
ENTER INC DEC EXIT
ADV/PASSWORD----------------
enter the password
141
ENTER INC DEC EXIT
Push the