Outback Power Systems VFX Series International Programming Manual - Manual (Page 22)

21
AC Breakers Off DC Breakers On
2. With the FXs connected to the HUB, turn only the DC breakers ON and power up the components.
All AC breakers should be OFF.
NOTE: For 3-phase stacking, the jumper in the HUB must be set to the 3- ph position. See the HUB User
Manual for further information.
NOTE: Powering up the FXs can cause the red
ERROR STATUS light to blink. After 5-10 seconds,
the green INVERTER light should be bright and
the ERROR and AC IN lights dark. The FX is now
producing AC output voltage.
LED Color LED Action LED Indicates
Green Solid GREEN Inverter ON
Flashing GREEN Search Mode Standby
Off Inverter OFF
Yellow Solid YELLOW AC Source is Connected
Flashing YELLOW AC Input Live-Waiting to
Connect to the FX
Off No AC Input Present
Red Solid RED Error-Error Message, dis-
plays on the MATE
Flashing RED Warning: Non-critical FX
fault, the MATE can access
this information
BYPASS OUTPUT INPUT