DAVIS FMS DriveRight Getting Started Guide (8186) User Manual

Page 11

Installing USB Drivers for the SmartCard Desktop Reader

DriveRight SmartCard Desktop Reader (# 8108) works with the DriveRight
SmartCard System to upload data from a DriveRight 600 or 600

to a computer

running DriveRight FMS version 3.3 or later. The SmartCard Desktop Reader
connects to a computer via a USB port. USB drivers must be installed for the
SmartCard Desktop Reader to properly communicate with DriveRight FMS. This
can be done during DriveRight FMS installation or at any time a SmartCard
Desktop Reader is present for set up. A SmartCard Desktop Reader must be
available, so it can be configured during driver installation.
The SmartCard Desktop Reader must be present in order to install the USB
driver. Before installing drivers, unplug the SmartCard Reader.

1. Navigate to the DriveRight directory via Windows Explorer or some other

means. A list of subfolders displays. Select/open SmartCard USB Drivers
folder.

2. Open the Athena folder or the ACS folder (depending of which type of

SmartCard Reader you are using), then double-click on Setup. The Installation
Wizard starts.

Follow these steps for Athena Drivers:

1. Double click to run setup4005x86-en.exe if you have 32-bit operating system or

setup4005x64-en.exe if you have 64-bit operating system.
The Installation Wizard starts. Click Next.

2. Select Typical and click Next.